GacoDeck Primer

Usage:
Intended for the following application: 

GacoDeck Primer is used for adhesion purposes before top coating existing waterproof membranes coated with Acrylic, Hypalon or Urethane waterproofing systems.

Limitations:
DO NOT apply on surfaces where water remains ponding for longer than 48 hours

Colors:
Gray

APPLIED PRODUCT DATA

Weatherability:
Must be top coated with GacoDeck Top Coat.

Tensile:
ASTM D-412

• Stength: 275 +/- 10 psi min. (1.90 +/- .07MPa)
• Elongation 200% +/- 10 min.
• Permanent Set At Break: 8% +/- 2

Hardness:
ASTM D-2240 Shore A, 65 +/- 2

Tear Resistance:
ASTM D-642 DIE C, 75 +/- 5 (13.4 +/- .5 kg / cm) Lb/in.

Water Vapor Permeability:
ASTM E-96 Procedure B, 0.06 Perm Inches (1.5 mm)
100% R.H. Difference R.T.

Toxicity
Not for use in contact with edible substances or potable water.

Adhesion:
Good adhesion to existing Acrylic, Urethane and Hypalon waterproofing membranes. Contact Gaco Western for specific recommendations.

PACKAGED PRODUCT DATA

Coverage:
951 (23.3 m2 / L / 0.025 mm) Sq. Ft./Gal./Mil

Solids

• Weight: Method 4041, 73.0%
• Volume: 59.3%

V.O.C.:
Contains less than 40 Grams/liter

Flash Point:
ASTM D-1310, Above 200°F(93°C). T.O.C

Storage Stablility: 
Three years in original unopened container. Protect from freezing. Freezing temperature 29°F (-2°C).Some separation can occur after storage of several months. Stir thoroughly before using to make homogeneous.

Thinning:
Thinning is not recommended under normal conditions. When desired, GacoDeck Primer may be thinned with water up to 5% with subsequent reduction in film build and vertical hold properties.

APPLICATION

Apply by spray, roller or brush at a rate of one gallon per 200 square feet (3.8 L / 20 square meters).

Clean up with GacoDeck Wash or water supplemented with liquid detergent.

GacoDeck Primer is water based and requires the complete evaporation of the water to achieve cure. DO NOT apply to surfaces that are, or will be lower than, 50°F (10°C). within 12 hours.